Nokia m1122 setup guide
Console based config.

The below shows the current config. To change any of these you need to 
type "configure" to go into config mode. You can then simply type in the 
info such as "eth1" to enter in to the local net config. Then enter the ip 
address and so on.

To quit out of config mode type quit. To logout of the modem type logout. 
Most of these generic commands can be displayed by typing help.


-----------------------------------------------------------------

login-id: admin
password: ********
PrimusInternet>show conf run
system
hostname PrimusInternet
eth
ip address {modem's internal ip} {subnet mask}
vcc1
pvc 8 35 ppp-vc
ppp authentication both-chap-pap
ppp username user@realm
ppp password {passwd}
ip address 0.0.0.0 0.0.0.0
vcc2
vcc3
vcc4
vcc5
vcc6
vcc7
vcc8
vbridge
mngtvcc
common
ip route 0.0.0.0 0.0.0.0 0.0.0.0 vcc1
ip route {extra network} {its network's subnet} {where routing to} eth
misc interwan-routing
PrimusInternet>


-----------------------------------------------------------------

now
if the user's modem is:
210.50.29.33

the extra subnet is:
210.50.29.36/29

and you want the second subnet pointing to the first
then in the common part youd write:

ip route 210.50.29.36 255.255.255.248 210.50.29.33 eth


There is also a web based front end. This is great for setting up the nat 
side of things. Of course you need to setup your local network before you 
can use this. The web based setup is covered in the nokia manual. I have 
some screenshots of it that I will upload once Ive got a program to resize 
and convert them.A