Connect to the modem via serial in hyper terminal (Bits per
second = 9600)

The commands are as follows.

ip device flush
ip subnet flush
ip route flush
ip ipatm pvc flush
r1483 pvc none
config save
restart


??:??:??:??:??:??> ip device add bridge ether //bridge 192.168.1.1
??:??:??:??:??:??> config save
??:??:??:??:??:??> restart


That should be it.

Use the diagnostic utility to set the VPI/VCI to 8/35

Then run PPPoe form the behind the bridge.